Showing minimum clearance width and shortest walking paths

1 min read

Available in
  • Professional
  • Desktop

Function#

The minimum clearance width describes the minimum distance between two objects that must exist in order to ensure accident-free walking and transport routes.

Instructions#

Show minimum clearance width#

The minimum clearance width is displayed as a yellow grid on the floor. This can be displayed by activating the teleport function on the controller with your thumb (or by holding it down longer). The grid is generated around all fixed objects (boxes, grid boxes). Moving objects (components, KLTs, CADs and gripping shells), objects lower than 5 cm and higher than 180 cm are not included in the calculation.

Factory hall with a yellow frame stand and lattice frame as seen from the controller, here without the clearance width displayed.

Show shortest walking and transport distance#

If you hold the touchpad down for longer (approx. 0.35 seconds), the shortest possible distance that the avatar would travel when teleporting is also displayed. The path and the distance are represented by a line on the ground. If you release the teleport button, the avatar will travel the exact path that was shown to you before.

Factory hall with yellow-marked areas and a blue line on the floor showing the shortest path the avatar would take when teleporting.

Adjusting the clearance width value#

You can adjust the value of the minimum clearance width individually in the settings window. To do this, select "Settings" in the menu and then the "Station" tab. Use the default values to adjust your clearance width. The grid is automatically recalculated and displayed.

View of a hall in Halocline Layout with walkways on the floor; in the background a frame and yellow platforms, plus the clearance width menu.

In the settings window you also have the option of permanently displaying the minimum clearance width. If you select this option, the visualisation on the ground is not only displayed when teleporting, but permanently.

Factory hall with a yellow frame stand and lattice frame; in the settings window you can show the clearance width on the floor permanently.